Client Problem: Our client lost his USB Cable, its a special type and was not able to get a replacement cable for it. The data was very important for him. Work Done: We soldered a usb wire directly onto the PCB of the device and copied the wav recordings to clients external hard drive …
Read More
Client Problem: Damaged USB Flash drive Damaged, recover very important DATA. Item: 4 gig USB Flash Drive. Male USB connector broke out of PCB connections. The client had it at a previous repairer causing even more damage to SMD components. Repair: replace burned 2.2 ohm resistors, we used 1/4 watt as we are going to…
Read More
Gemsound Car Radio Repaired Model : GM-5080 Client Problem: CD player not reading Disks No Sound output Repair: We serviced the lens assembly and aligned the lens, and replaced the Sound Output IC If you need a repair like this contact us. Email : servicecentresasol@telkomsa.net or Tell: 016 973 3360
Read More
Sony amp model str-dk5 repaired no power no sound. Repair: Replace Mains Transformer, replace 2 output Transistors, fusible resistors. PCB clean Solder Joints Re solder
Read More
Telefunken Model: TMDL-200A dvd Read problem Repaired Client Problem: Tray Open Close Error Disk Read error Repair: Replace Loading Belt, Lens Clean Service and Adjust
Read More
Repair done to Dixon Amp Model: K2250USB Client Problem: Sound Distort Repair: Replace 2 x 4700 x 50v Cap , Rectifying Bridge.
Read More
LG 54cm Tv Model: CS-20F60 Repaired. Client Problem: Stuck in Stand by. Rapair: PCB Clean re-solder dry solder joints. Replace secondary power supply leaky capacitors, replace Line output IC
Read More
Local Attorneys office 2 networks points and switch installed Work done: Lay of 64 meter UTP cat 5 from ADSL router. Install of a 24 port switch install of 2 network connections. If you need a new office network or Internet installation Contact us.
Read More
Client Problem : Volume POT not Working, RCA plugs Damaged. Repair, replace RCA plugs Replace Volume POT Dixon amp repair model sdj-1506A
Read More
The client accidentally damaged his Hasp Cad Software dongle and was so stressed as these dongles to replace cost a arm and a leg. We opened the dongle and soldered a standard USB printer cable to the PCB of the Hasp Dongle. We removed the SMD notification LED and replaced it with a 5mm LED.…
Read More
 Visit Today : 7 |
 Visit Yesterday : 36 |
 This Month : 741 |
 This Year : 5980 |
 Total Visit : 19664 |
 Hits Today : 30 |
 Total Hits : 59782 |
 Who's Online : 1 |